Speed Queen W446I User Manual

Page 18

Text mode
Original mode

Installation

38970

Step 7: Add Water to the Washer

To prevent damage to pump, do not run washer before
adding at least one quart water to the tub. If the washer
is run before any water is added, the pump seal may
overheat, causing the pump to leak. Once installed, the
water retained in the drain system from the previous
cycle will provide sufficient cooling to prevent pump
seal damage.

NOTE: The agitator should not be removed except
for service. The washtub is designed to be self-
cleaning.

Figure 11

Step 8: Check Lid Switch

Washer should stop filling, agitating and spinning
when lid is opened.

Figure 12

Step 9: Check Installation

Refer to Installer Checklist on the back cover of this
manual and make sure that washer is installed
correctly.

TLW524N

TLW1974N