SUPER MICRO Computer 6014P-TR - Manual (Page 70)

6-12
S UPER S ERVER 6014P-T/6014P-TR User's Manual
5. Pull the left-side (when viewed from the rear of the system) power supply out
of the chassis. Note that the power distribution board contacts for this power
supply are now exposed. Supermicro does not supply a shield to protect these
contacts, you must do so on your own.
6. Reinstall the riser card bracket.
7. You may now add a left-side riser card (purchased separately*) and a PCI-
X/PCI-Express expansion card in the space vacated by the second power supply
module, if desired.
8. Reattach the COM port header to the space provided in the new backpanel
section.
9. Replace the chassis cover, push the system back into the rack and reconnect
the power cord (to only a single power module now). Power up the system.
* CSE-RR1U-X (for PCI-X cards) or CSE-RR1U-EL (for PCI-Express cards).
Important: Reconfi guring the 6014P-TR as a single power supply system
is not recommended. If you do reconfi gure the 6014P-TR, it is extremely
important that you install a shield (not included) to protect the power distri-
bution board contacts that were used by the second power supply module
(see step 5 above).
! !