3 server chassis features – SUPER MICRO Computer 6014P-TR User Manual
Page 13
1-3
Chapter 1: Introduction
ATI Graphics Controller
The X6DHP-TG features an integrated ATI video controller based on the Rage XL
graphics chip. Rage XL fully supports sideband addressing and AGP texturing.
This onboard graphics package can provide a bandwidth of up to 512 MB/sec over
a 32-bit graphics memory bus.
Other Features
Other onboard features that promote system health include onboard voltage moni-
tors, a chassis intrusion header, auto-switching voltage regulators, chassis and CPU
overheat sensors, virus protection and BIOS rescue.
1-3 Server
Chassis
Features
The SuperServer 6014P-T/6014P-TR is a high-end, scaleable server platform built
upon the SC814+T-560/SC814+T-R560 1U server chassis. The following is a gen-
eral outline of the main features of the SC814T-560/SC814T-R560 chassis.
System Power
6014P-T: the SC814+T-560 features a single 560W cold-swap power supply. Power
must be removed from the system before servicing or replacing the power supply.
6014P-TR: the SC814+T-R560 features a redundant 560W hot-swap power supply
that consists of two power modules. One power supply module will take over if the
other fails. The hot-swap capability allows you to replace a failed power supply
module without having to power down the system.
Serial ATA Subsystem
The SC814+T-560/SC814+T-R560 chassis was designed to support four Serial
ATA hard drives, which are hot-swappable units.
Note: The operating system you use must have RAID support to enable the hot-
swap capability of the Serial ATA drives.