Star Trac Pro S - Manual (Page 17)

Position the bottom of each handrail over its associated mounting hole in the frame assembly. Insert one 5/16” x 7.5” screw,
with a flat washer installed, through the bottom of the frame assembly, and thread into each handrail. Use
9 1/2” wrench
to tighten the screws.
6. Connecting the Display Cables
For units with fans (PRO / PRO ELITE) , connect the cables tagged 715-3444 and 715-3419 from the display to connectors
J3A and P4A, respectively, on the 715-3441 PCB in the motor compartment. The display cable connectors are keyed, and
can only be installed in one direction only.
Connect the cable tagged 715-3411 from the display to connector
P3 on the 715-3397 (for 110-volt) or 715-3398 (for 220-volt) PCB in
the motor compartment. The display cable connector is keyed, and
can only be installed in one direction only.
STAR TRAC PRO S / PRO / PRO ELITE TREADMILL O
WNER
’
S
M
ANUAL
15
Step 5e
Step 6a
Step 6b