First steps, Pack contents, Setting up the handset for use – Siemens Gigaset C450 IP User Manual
Page 7: Inserting the batteries, Connecting the charging cradle, Pack contents setting up the handset for use

6
First steps
Gigaset C450 IP / Greek eng / A31008-M1713-T151-2-8U19 / starting.fm / 19.9.06
Ve
rs
ion 4,
16
.09.
2005
First steps
Pack contents
The pack contains:
u
one Gigaset C450 IP base station
u
one Gigaset C45 handset
u
one mains adapter for the base station
u
one charging cradle incl. mains adapter
u
one phone cord
u
one Ethernet cable (LAN cable)
u
two batteries
u
one battery cover
u
one belt clip
u
one quick guide
Setting up the handset for use
The display is protected with
a plastic film. Please
remove the protective
film!
Inserting the batteries
¤
Insert the batteries the right way round
(see figure).
The polarity is indicated in the battery
compartment.
The handset switches on automatically.
You will hear a confirmation tone.
Closing the battery cover
¤
Place the cover on the battery compart-
ment as shown in the diagram, then
push it up until it clicks into position.
Opening the battery cover
¤
Press down on the battery cover below
its upper end and slide the cover down.
Connecting the charging cradle
Connecting up the charging cradle and
mounting it on the wall (if required) is
described at the end of this user guide.
¤
To charge the batteries, leave the hand-
set in the charging cradle.
For questions and problems see page 61.
Caution:
Use only the rechargeable batteries recom-
mended by Siemens Home and Office
Communication Devices GmbH & Co. KG on
page 68! This means: on no account may
conventional (non-rechargeable) batteries or
other battery types be used, otherwise serious
damage to health and property cannot be
ruled out, e.g. the outer casing of the batteries
could be destroyed or the batteries could
explode. The phone could also malfunction or
be damaged as a result of using batteries that
are not of the recommended type.
Notes:
– Only place the handset in the charging cra-
dle that is intended for it.
– If the handset has switched itself off
because the batteries are flat and if it is
then placed in the charging cradle, it will
switch itself on automatically.