Siemens Gigaset C450 IP - Manual (Page 42)

41
Base station settings
Gigaset C450 IP / Greek eng / A31008-M1713-T151-2-8U19 / settings_bs_hs_pabx.fm / 19.9.06
Ve
rs
ion 4,
16
.09.
2005
Activating/deactivating repeater
mode
With a repeater you can increase the range
and reception strength of your base sta-
tion. You have to activate the repeater
mode for this. This will terminate any calls
being made via the base station at that
time.
Precondition: a repeater is registered.
§Menu§
¢
Settings
¢
Base
¢
Additional
Features
¢
Repeater Mode
Select and press §OK§ ( ‰ = on).
Setting up an emergency
number
Emergency numbers have been preset in
your phone. They cannot be amended. In
addition, you can specify you own emer-
gency number.
§Menu§
¢
Settings
¢
Base
¢
Additional
Features
¢
Additional Emergency No.
~ Enter the system PIN and press
§OK§ .
If an additional emergency number has
been saved, it is displayed.
~
Enter emergency number and
press §OK§ .
Set default connection
You can make settings according to
whether you want to make calls via VoIP or
fixed network by default.
§Menu§
¢
Settings
¢
Base
¢
Default Line
Type
IP / fixed line
Select and press §OK§ ( ‰ = on).
When making calls:
¤
Briefly press the talk key c if you want
to make a call via this default connec-
tion.
¤
Press and hold the talk key c if you
want to make a call via the other con-
nection type.
Updating the base station
firmware
If necessary, you can update your base sta-
tion firmware.
The firmware update is downloaded
directly from the Internet by default. The
relevant website is preconfigured in your
phone.
As an alternative to uploading the
firmware via the Internet, it can also be
loaded from a local PC. You can specify the
PC via the Web configurator (page 57).
This setting applies only to the next
firmware update.
Precondition:
The base station is in idle status, i.e.:
u No calls are being made via the fixed
network or VoIP.
u There is no connection between regis-
tered handsets.
u No other handset has opened the base
station menu.
Starting firmware update
§Menu§
¢
Settings
¢
Base
¢
Firmware
Update
~ Enter base station system PIN
(default setting: 0000).
The base station establishes a connection
to the Internet or to the local PC.
§Yes§ Press display button to start
the firmware update.
Note:
In default setting for your phone is that emer-
gency numbers are automatically dialled via
the fixed network. You can change this setting
(page 56).