Siemens Gigaset C450 IP - Manual (Page 45)

44
Operating the base station on the PABX
Gigaset C450 IP / Greek eng / A31008-M1713-T151-2-8U19 / settings_bs_hs_pabx.fm / 19.9.06
Ve
rs
ion 4,
16
.09.
2005
Activating/deactivating display
of VoIP status codes
If the function is activated, a VoIP status
code for your service provider is displayed.
Activate the function e.g. if you have prob-
lems with VoIP connections. You will
receive a provider-specific status code,
which supports the service when the
problem is analysed.
§Menu§
¢
Settings
¢
Base
¢
VoIP
Configuration (enter system PIN)
¢
IP
Configuration
Status on HS ( ‰ = on)
Select and press §OK§ .
Check the base station MAC
address
Depending on your network configura-
tion, it may be that you have to enter your
base station MAC address e.g. into your
router's access control list. You can check
your base station MAC address:
§Menu§
4 I O 2 Q
The base station MAC address is displayed.
a
Press and hold (idle status).
Operating the base station
on the PABX
The following settings are only necessary
when your PABX requires them; see the
PABX User Guide. The settings only con-
cern fixed network connections.
You cannot send or receive SMS messages
on PABXs that do not support Calling Line
Identification.
Changing the dialling mode
You can set the dialling mode.
§Menu§
¢
Settings
¢
Base
¢
Additional
Features
¢
Dialling Mode
Tone / Pulse
Select and press §OK§ ( ‰ = on).
a Press and hold (idle status).
Setting the flash time
You can set the flashing time.
§Menu§
¢
Settings
¢
Base
¢
Additional
Features
¢
Recall
q Select flashing time and press
§OK§ .
The current setting is marked with ‰.
a Press and hold (idle status).
Notes:
– For how to make the setting on the
Web configurator, see page 59.
– A table with possible status codes and their
meaning can be found in the Appendix on
page 63.