Sierra Wireless AirCard 555 - Manual (Page 49)

Chapter 5: Data Connections
Rev 3.0 Dec.01 49
Installat
ion and Use
o
n
Note
book
PCs
To terminate an incoming call:
1. Click the Cancel button (during the connection process) or
the Disconnect button (once the connection is established).
Quick 2 Net Connections
The Quick 2 Net connection is set up for you when Watcher is
installed. All you need to do to make the connection is:
1. Select Quick 2 Net (14.4 kbps) from the drop-down menu on
the Data tab of the main Watcher window.
2. Click the Connect button.
Once connected you can use any Internet application (such as
Internet Explorer, Netscape Navigator, or your e-mail appli-
cation).
To terminate a Quick 2 Net connection:
1. Click the Cancel button (during the connection process) or
the Disconnect button (once the connection is established).
Express Network Connections
Note: The 1xRTT
indicator only shows that 1xRTT
service is available; it does not
indicate whether voice or packet
service is available.
An Express Network connection can be established only in
areas where 1xRTT packet service has been implemented. To
make an Express Network connection:
1. Select Express Network (1xRTT) from the drop-down menu
on the Data tab of the main Watcher window.
2. Click the Connect button. (No phone number or dialing is
required.)
Note: Depending on a setting in
the Options window, a message
warning you of a possible
surcharge for 1xRTT service
may be displayed whenever you
establish a 1xRTT connection.
This warning message can be
disabled in the Options window.
See page 75. Once the connection is established, you can use any Internet
application (such as Internet Explorer, Netscape Navigator, or
your e-mail application).
To terminate an Express Network connection:
1. Click the Cancel button (during the connection process) or
the Disconnect button (once the connection is established).