SMC Networks 16 10BASE-T - Manual (Page 268)

Command Line Interface
4-92
4
Command Usage
A packet matching a rule within the specified ACL is mapped to one of the
output queues as shown in the following table. For information on mapping the
CoS values to output queues, see queue cos-map on page 4-166.
Example
Related Commands
queue cos-map (4-166)
show map access-list ip (4-92)
show map access-list ip
This command shows the CoS value mapped to an IP ACL for the current interface.
(The CoS value determines the output queue for packets matching an ACL rule.)
Syntax
show map access-list ip [interface]
interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
Command Mode
Privileged Exec
Example
Related Commands
map access-list ip (4-91)
Table 4-34. Egress Queue Priority Mapping
Queue
0 1 2 3
Priority
1,2 0,3 4,5 6,7
Console(config)#interface ethernet 1/25
Console(config-if)#map access-list ip bill cos 0
Console(config-if)#
Console#show map access-list ip
Access-list to COS of Eth 1/24
Access-list ALS1 cos 0
Console#