SMC Networks 16 10BASE-T - Manual (Page 114)

Configuring the Switch
3-78
3
Web – Click Port, Port/Trunk Broadcast Control. Set the threshold, mark the
Enabled field for the desired interface and click Apply.
Figure 3-47. Enabling Port Broadcast Control
CLI – Specify any interface, and then enter the threshold. The following disables
broadcast storm control for port 1, and then sets broadcast suppression at 600
octets per second for port 2.
Console(config)#interface ethernet 1/1 4-104
Console(config-if)#no switchport broadcast 4-110
Console(config-if)#exit
Console(config)#interface ethernet 1/2
Console(config-if)#switchport broadcast octet-rate 600
4-110
Console(config-if)#end
Console#show interfaces switchport ethernet 1/2
4-113
Information of Eth 1/2
Broadcast threshold: Enabled, 600 octets/second
Lacp status: Enabled
Ingress rate limit: disable, Level: 30
Egress rate limit: disable, Level: 30
VLAN membership mode: Hybrid
Ingress rule: Disabled
Acceptable frame type: All frames
Native VLAN: 1
Priority for untagged traffic: 0
Gvrp status: Disabled
Allowed Vlan: 1(u),
Forbidden Vlan:
Private-VLAN mode: NONE
Private-VLAN host-association: NONE
Private-VLAN mapping: NONE
Console#