SMC Networks 16 10BASE-T - Manual (Page 165)

Class of Service Configuration
3-129
3
Command Attributes
• DSCP Priority Table – Shows the DSCP Priority to CoS map.
• Class of Service Value – Maps a CoS value to the selected DSCP Priority value.
Note that “0” represents low priority and “7” represent high priority.
Note: IP DSCP settings apply to all interfaces.
Web* – Click Priority, IP DSCP Priority. Select the required interface, select an entry
from the DSCP table, enter a value in the Class of Service Value field, then click
Apply.
Figure 3-78. Mapping IP DSCP Priority Values
CLI* – The following example globally enables DSCP Priority service on the switch,
maps DSCP value 0 to CoS value 1 (on port 1), and then displays the DSCP Priority
settings.
* Mapping specific values for IP DSCP is implemented as an interface configuration
command, but any changes will apply to the all interfaces on the switch.
Console(config)#map ip dscp 4-172
Console(config)#interface ethernet 1/1 4-104
Console(config-if)#map ip dscp 1 cos 0 4-172
Console(config-if)#end
Console#show map ip dscp ethernet 1/1
4-175
DSCP mapping status: disabled
Port DSCP COS
--------- ---- ---
Eth 1/ 1 0 0
Eth 1/ 1 1 0
Eth 1/ 1 2 0
Eth 1/ 1 3 0
.
.
Eth 1/ 1 61 0
Eth 1/ 1 62 0
Eth 1/ 1 63 0
Console#