Sharp VC-MH835HM - Manual (Page 45)

43
www.sharp.co.uk/support
MORE INFORMATION ABOUT YOUR VCR
ON-SCREEN DISPLAY
All the information you need on the VCR status will be summarised on the on-screen display.
If you are recording, playing back a tape or watching a broadcast on the video channel you
can call up three standard on-screen displays. The display can be selected by pressing the
MODE OSD button on the remote control, 1,2,3 or 4 times.
1. AUTO , the current mode and channel
number will be displayed for 3 seconds when an
operation or number button is pressed.
3. COUNTER , this display will show the tape
counter and amount of tape remaining.
4. DISPLAY OFF , this will remove the display
from the screen.
NOTES:
• The default time and date will not be displayed if the clock has not been set.
• The VCR will return to display 1 . each time it is switched on.
• If you are recording from this VCR to another, make sure you remove the display from
the screen otherwise it will be recorded.
1.
■ 1 CH 5 9
N I CAM
S T E R EO
S P L R
Programme number and channel
Tape Status
NICAM signal
Audio output mode
Tape speed
Tape remaining
Time
Date
Tape counter
2.
■ 1 CH 5 9
S U P E R P . ON N I CAM
S T E R EO
S P L R
2 2 : 0 0 R EM 1 : 0 5
9 / 0 7 0 2 0 : 0 0 . 0 0
3.
R EM 1 : 0 5
0 : 0 0 . 0 0
2. FULL , all the active features will also be
shown on screen.
TINS-A082UMN1.book Page 43 Monday, November 4, 2002 2:33 PM