Sharp VC-MH835HM - Manual (Page 43)

41
www.sharp.co.uk/support
CUSTOMISED INSTALLATION
MANUALLY SETTING THE CLOCK
The clock will normally be set using teletext information when your VCR automatically tunes in
the broadcast channels. If for any reason teletext signals are not present, your VCR will not be
able to set the clock. This procedure will allow you to set the clock manually.
1. Press the MENU button.
2. Press the [ / ] menu select buttons to
select SET UP. Press the SET button to
confirm.
3. Press [ / ] to select CLOCK. Press the
SET button to confirm.
4. Press [ / ] to select either 12 or 24 hour
clock.
5. Press [ / ] to select TIME. Enter the time
using the NUMBER BUTTONS or the
[ / ] buttons. If the minutes or hours are
less than 10, enter the leading 0. If using the 12
hour clock enter AM or PM by pressing the
AM/PM button on the remote control.
6. Press [ / ] to select DATE. Enter the date
using the NUMBER BUTTONS or the
[ / ] buttons. For example, for 1st April
enter 01 04 .
7. Press [ / ] to select YEAR. Enter the last two
digits of the year using the NUMBER
BUTTONS or [ / ]. For example, for
2002 enter 02 . For the year 2003 enter 03 .
8. AUTO CLOCK SETTING .
Press [ / ] to select ✱ . Press [ / ]to
change between AUTO CLOCK on/off
( ✱ is ON , - is OFF ). Then press the SET
button to confirm.
NOTE:
• If AUTO CLOCK is set to OFF ( - is OFF ) then you will need to update the clock for
daylight saving.
S E T U P
CHANN E L P R E S E T
CHANN E L SOR T
C L OCK
į Ĭ : S E L EC T ǡ Ǡ : CHANGE
S E T : E N T E R ME NU : E X I T
C L OCK
MOD E T I ME DA T E Y E AR
2 4 H 0 : 0 0 0 1 / 0 4 0 2 *
MOD E : 2 4 H / 1 2 H
ǡ Ǡ : S E L EC T į Ĭ : CHANGE
S E T : E N T E R ME NU : E X I T
Remote Control
MENU SELECT
BUTTONS
MENU
SET
3.
4.
SET
SET
SET
TINS-A082UMN1.book Page 41 Monday, November 4, 2002 2:33 PM