Manually tuning a channel continued – Sharp VC-MH835HM User Manual
Page 37
35
www.sharp.co.uk/support
CUSTOMISED INSTALLATION
MANUALLY TUNING A CHANNEL CONTINUED
7.
Press [
/
]to select
CHANNEL
.
8.
Press [
/
] to start tuning in either
direction. Tuning will stop when a channel is
received. If it is not the desired channel, press
[
/
] to continue tuning.
9.
Press [
/
] to select
FINE TUNING
.
Press and hold [
/
] until the sharpest
colour picture is obtained.
11.
Press [
/
] to select
SKIP
then [
/
]
to select ON or OFF.
12.
Press
SET
to store this channel. The VCR
will increment to the next channel up.
•
If any more channels are to be tuned in,
repeat this procedure.
•
Once all the channels have been tuned in.
Press
MENU
to return to the normal
screen.
IMPORTANT NOTE:
10.
Press [
/
] to select
DECODER
. This
is preset to OFF. If you connect a satellite
receiver into VCR L2, as shown previously,
leave decoder OFF. If you connect a
decoder, as shown previously, you must
use [
/
] to turn the decoder function
ON. Refer to
DECODER SWITCHING
OPERATION
.
The SKIP function determines whether the
channel can be selected when using the
VCR CHANNEL
/
buttons
instead of the
NUMBER BUTTONS
.
MENU SELECT
BUTTONS
MENU
SET
REMOTE CONTROL
SET
2
3
1
VIDEO
Plus+
TINS-A082UMN1.book Page 35 Monday, November 4, 2002 2:33 PM