Woodstock SHOP FOX W1824 - Manual (Page 75)

Df[\cN(/)+('?pYi`[KXYc\JXn
-73-
G8
I
K
J
GIF9C GFJJ@9C<:8LJ< :FII<:K@M<8:K@FE
Blade is not aligned with
miter slot or fence. 1. Blade is warped.
2. Table top is not parallel to blade.
3. Fence is not parallel to blade.
1. Replace blade (see Page 27).
2. Make miter slot parallel to blade (see Page 60).
3. Make fence parallel to blade (see Page 66).
Blade does not reach 90°. 1. 90° stop collar is out of adjust-
ment.
2. Sawdust stuck on stop collar.
1. Adjust 90° stop collar (see Page 58).
2. Clean sawdust off stop collar.
Blade hits insert at 45°. 1. 45° stop collar is out of adjust-
ment.
2. Sawdust stuck on stop collar.
3. Slot in insert is inadequate.
4. Table out of alignment.
5. Blade position is incorrect.
1. Adjust 45° stop collar (see Page 59).
2. Clean sawdust off stop collar.
3. File or mill the slot in the insert.
4. Align miter slot to the blade (see Page 60).
5. Adjust blade position.
Board binds or burns when
feeding through table saw. 1. Dull blade.
2. Blade is warped.
3. Fence is not parallel to blade.
4. Table top is not parallel to blade.
1. Replace blade (see Page 27).
2. Replace blade (see Page 27).
3. Make fence parallel to blade (see Page 65).
4. Make miter slot parallel to blade (see Page 60).