Woodstock SHOP FOX W1824 - Manual (Page 16)

Df[\cN(/)+('?pYi`[KXYc\JXn
-14-
J<
K
L
G
The following is a description of the main components
shipped with the Model W1824. Lay the components out
to inventory them.
Efk\1 If you can't find an item on this list, check the
mounting location on the machine or examine the
packaging materials carefully. Occasionally we pre-install
certain components for safer shipping.
Shipping Inventory: (Figures 7–10) Qty
A. Cabinet Assembly ..........................................1
B. Extension Wings ............................................2
C. Saw Blade 10" x 40T .......................................1
D. Wrench 7⁄16" x 13mm ....................................1
E. Arbor
Wrench 24mm ......................................1
F. Access Door .................................................1
G. Blade Guard Assembly & Riving Knife ........... 1 Each
H. Push
Stick ...................................................1
I. Handwheel Handles .......................................2
J. Miter Gauge ................................................1
K. Hex Wrench 6-Piece Set 2.5-8mm ......................1
L. Dado
Table Insert ..........................................1
M. Fence Rail Tube 58" w/Scale ............................1
N. Rear Rail 53" (6-Holes) ....................................1
O. Front Rail 53" (6-Holes) ...................................1
P. Fence
Assembly ............................................1
Q. Extension Table ............................................1
Hardware (Not Shown) Qty
• Cap Screws M5-.8 x 12 (Mag Switch) ...................2
• Lock Washers 5mm (Mag Switch) .......................2
• Flat Washers 5mm (Mag Switch) ........................2
• Flat Head Screws M8-1.25 x 35 (Front Rail/Tables) ..6
• Flat Washers 8mm (Front Rail/Tables) .................8
• Lock Washers 8mm (Front Rail/Tables) ................6
• Hex Nuts M8-1.25 (Front Rail/Tables) ..................6
• Cap Screws M6-1 x 16 (Front Rail/Tube) ...............5
• Flat Washers 6mm (Front Rail/Tube) ...................5
• Lock Washers (Front Rail/Tube) .........................5
• Hex Bolts M10-1.5 x 25 (Rear Rail/Table) .............2
• Flat Washers 10mm (Rear Rail/Table) ..................2
• Lock Washers 10mm (Rear Rail/Table) .................2
• Hex Bolts M8-1.25 x 35 (Rear Rail/Wing/Ext Table) .4
• Hex Nuts M8-1.25 (Rear Rail/Wing/Ext Table) ........4
• Flat Washers 8mm (Rear Rail/Wing/Ext Table) .......8
• Lock Washers 8mm (Rear Rail/Wing/Ext Table) ......4
Inventory
Figure 7. Cabinet assembly.
A
Figure 8. Extension wings.
B
Figure 10. Fence components.
M
N
O
P
Q
Figure 9. Small components.
C
D
F
G
H
I
J
K
L
E