Woodstock SHOP FOX W1824 - Manual (Page 56)

Df[\cN(/)+('?pYi`[KXYc\JXn
-54-
D
8
@EK<
E8E:
<
MAINTENANCE
D8B< JLI< k_Xk pfli dXZ_`e\ `j
legcl^^\[ [li`e^ Xcc dX`ek\eXeZ\
gifZ\[li\j@]k_`jnXie`e^`j`^efi\[#
j\i`fljg\ijfeXc`ealipdXpfZZli%
Cleaning the Model W1824 is relatively easy. Vacuum
excess wood chips and sawdust, and wipe off the
remaining dust with a dry cloth. If any resin has built up,
use a resin dissolving cleaner to remove it. After cleaning,
treat all unpainted cast iron and steel with a non-staining
lubricant.
Occasionally it will become necessary to clean the
internal parts with more than a vacuum. To do this,
remove the table top and clean the internal parts with
resin/pitch dissolver or mineral spirits and a stiff wire
brush or steel wool. DO NOT USE WATER—WATER WILL
CAUSE CAST IRON TO RUST.
Make sure the internal workings are dry before using
the saw again, so that wood dust will not accumulate.
If any essential lubrication is removed during cleaning,
re-lubricate those areas.
Cleaning
For optimum performance from your machine, follow this
maintenance schedule and refer to any specific instructions
given in this section.
;X`cp:_\Zb1
•
Inspect blades for damage or wear.
• Check for loose mounting bolts/arbor nut.
• Check cords, plugs, and switch for damage.
• Check for the proper function of the blade guard
(see Blade Guard Assembly on Page 28).
• Check for any other condition that could hamper the
safe operation of this machine.
• Wipe the table clean after every use—this ensures
moisture from wood dust does not remain on bare
metal surfaces.
N\\bcpDX`ek\eXeZ\1
•
Wipe down the table surface and grooves with a
lubricant and rust preventive such as SLIPIT
® .
• Vacuum dust buildup from the motor housing and
trunnions.
• Clean the pitch and resin from the saw blade with a
cleaner like OxiSolv
® Blade & Bit Cleaner.
Dfek_cpDX`ek\eXeZ\1
›
Check/tighten the belt tension ( GX^\,-).
Schedule