Woodstock SHOP FOX W1824 - Manual (Page 24)

Df[\cN(/)+('?pYi`[KXYc\JXn
-22-
FG
<
I
8
K@FEJ
OPERATIONS
General
This machine will perform many types of operations
that are beyond the scope of this manual. Many of these
operations can be dangerous or deadly if performed
incorrectly.
The instructions in this section are written with the
understanding that the operator has the necessary
knowledge and skills to operate this machine. If at any
time you are experiencing difficulties performing any
operation, stop using the machine!
If you are an inexperienced operator, we strongly
recommend that you read books or trade articles, or seek
training from an experienced table saw operator before
performing any unfamiliar operations.
8Yfm\Xcc#pfli
jX]\kpj_flc[Zfd\]`ijk
READ and understand this entire
manual before using this machine.
Serious personal injury may occur if
safety and operational information is
not understood and followed. DO NOT
risk your safety by not reading!
LJ< k_`j Xe[ fk_\i dXZ_`e\ip n`k_
ZXlk`fe Xe[ i\jg\Zk% 8cnXpj Zfej`[\i
jX]\kp ]`ijk# Xj `k Xggc`\j kf pfli
`e[`m`[lXc nfib`e^ Zfe[`k`fej% Ef c`jk
f]jX]\kp^l`[\c`e\jZXeY\Zfdgc\k\Ç
\m\ip j_fg \em`ifed\ek `j [`]]\i\ek%
=X`cli\kf]fccfn^l`[\c`e\jZflc[i\jlck
`e j\i`flj g\ijfeXc `ealip# [XdX^\ kf
\hl`gd\ekfigffinfibi\jlckj%
Use the following descriptions and refer to Figure 27 to
gain an understanding of the basic controls of this table
saw.
A. Blade Height Handwheel & Lock. Adjusts the blade
height. To set the blade height, loosen the lock knob
in the center of the handwheel, turn the handwheel
to set the blade height approximately
1 ⁄
4
" higher
than the workpiece (for through cuts only), then
re-tighten the lock knob.
B. START/STOP Switch. Starts and stops the motor.
The START button has a hole through it that
accommodates a pin to disable the switch against
unauthorized usage.
C. Fence Lock. Secures the fence in place. After
adjusting the fence to the desired width of cut, lock
it in place by firmly pushing the fence lock down
until it stops.
D. Blade Tilt Handwheel & Lock. Adjusts the blade
tilt. Loosen the lock knob in the center of the
handwheel, turn the handwheel to position the blade
at the desired angle, then re-tighten the lock knob.
Figure 27. Model W1824 basic controls.
B
A
D
C
Basic Controls