Siemens SLI-5310 - Manual (Page 54)

Chapter 3: Accessing the Internet
Chapter 3: Accessing the Internet
This chapter aims to help you access the Internet in a quick and
convenient way. If you need more detailed information for web
configuration, please refer to the next chapter for the advanced
configuration.
Before configuring the IAD, you must decide whether to configure the device as a
bridge or as a router. This chapter presents some deployment examples for your
reference. Each mode includes its general configure procedures. For more detailed
information about web configuration, refer to "Web Configuration".
PPP over ATM (PPPoA)
PPP over Ethernet (PPPoE)
Numbered IP over ATM (IPoA)
Numbered IP over ATM (IPoA) + NAT
Unnumbered IP over ATM (IPoA)
Unnumbered IP over ATM (IPoA) + NAT
Bridge Mode
MER (Bridge Mode + NAT)
To ensure your PC accessing the Internet successfully, please check the following
first.
A network interface card is installed on your PC.
The IAD is solidly connected with your computer.
The TCP/IP protocol has been installed and the IP address setting is to
obtain IP address automatically.
When all above preparations are ready, you can open the Browser and type
“192.168.1.1” into the URL box and start to make the web configuration for different
connection modes.
This chapter is going to introduce the function of each connection mode and the
basic configuring steps that you have to do. If you do not follow the configuring steps
for using these connection modes, you might get some connection problems and
cannot connect to the Internet well.
46