JVC VN-C655 - Manual (Page 28)

28
2.
Check settings.
3.
Click .
4.
Start up the "V.Networks Controller".
(
☞
Page 29)
Click .
[V.Networks ID] works as an identification
code set to VN-C655. Only alphanumeric
characters can be used.
This ID does not directly affect operation
by the user.
Normally, the ID is set as CAM00001,
CAM00002, etc.
(0 to 8 characters)
1 Select whether to use DHCP.
2-3 Setting IP Address for this Camera Using the "VN-C655U Setup Tool" (Continued)
Note
The IP address of the DHCP server
and other information can be checked
when [DHCP] is selected.
2 Change the IP address to the one assigned
to or approved by the administrator.
3 Set Subnet mask to an appropriate value.
Ask the network administrator if necessary.
Note
Upon clicking OK, VN-C655 will be
automatically reset and the set values
will be enabled.
Note
In a system where more than 1 VN-C655 is used, turn on the power for a VN-C655 first, followed
by setting the camera until "2-3 Setting IP Address for this Camera Using the 'VN-C655U Setup
Tool' " is completed. Upon doing so, turn on a second camera and perform setting in the same
way. Perform the same procedure for subsequent cameras.
4 Click .
Settings (Step 2 Network Settings)
C655(B)_p22-28 05.3.17, 2:06 PM 28