JVC VN-C655 - Manual (Page 16)

16
Preparation (Step 1 Connection/Installation)
Connecting a 5C-2V or 3C-2V coaxial cable
Strip the coaxial cable according to the
diagram on the left. (Unit: mm)
1-1 Connecting Cables (Continued)
5. Connection of Coaxial Cables
7
*
17
Polyethylene
Mesh
Wires
Insulation Tape
Core Wire
Notes
• 7C-2V coaxial cables cannot be connected
directly to the terminal block. In this case,
make use of the 5C-2V cable as a junction
cable by connecting it to this camera.
* Fold back the mesh wires and secure
using an insulation tape to prevent them
from becoming loose and causing a
short circuit.
• Video output signal of the VIDEO OUT
terminal is restricted to NTSC signals.
● When mounting the coaxial cable in parallel with
the ceiling mount, remount the provided Cable
plate as shown in the figure.
Provided screw
Provided cable
plate
Screw removed
in the figure on
the left
VN-C655(B)_0202_p2-21 05.3.16, 6:24 PM 16