JVC VIDEO PLUS HR-S6965EK - Manual (Page 41)

advanced features 41
Editing Using Another VCR
connect up Connect the player’s 21-pin SCART connector to the recorder’s
21-pin SCART connector as illustrated.
A
When using your VCR as the player ...
... connect its L-1 IN/OUT connector to another VCR.
B
When using your VCR as the recorder ...
... connect its L-2 IN/DECODER or L-1 IN/OUT connector to another VCR.
set vcr’s input mode The recording VCR mode must be set to AUX . If this
VCR is the recorder, press AUX and/or PR to select L-1 (if you’ve used the L-2 IN/
DECODER connector) or L-2 (if you’ve used the L-1 IN/OUT connector). If this
VCR is the player, set O.S.D. to OFF . (
੬ pg. 42)
set edit mode See Picture Control on page 31.
start source vcr
Engage its PLAY mode.
start recording vcr Engage its RECORD mode.
NOTES:
• All necessary cables can be obtained from your dealer.
• For Y/C signal input/output, be sure to use a 21-pin SCART cable that is
compatible with the Y/C signal.
• When you set PICTURE CONTROL to EDIT to dub tapes (
੬ pg. 31), be sure to
select AUTO (or NORM when B.E.S.T. is set to OFF ) after you finish dubbing the
tapes.
HR-S6965EK-EN/p29-42 2/19/03, 07:56 PM 41