Connecting a usb mass storage class device, Connecting the power cord, Connections – JVC TH-C90 User Manual
Page 18
15
You can connect a USB mass storage class device such as a USB
flash memory device, hard disc drive, multimedia card reader,
digital camera, etc. to this system.
• After connecting a USB mass storage class device to this system
and selecting USB MEMORY as the source, the file control
display appears on the TV screen. (See page 30.)
NOTE
• When connecting a USB mass storage class device, refer also to its
manual.
• Connect one USB mass storage class device to the system at a time. Do
not use a USB hub.
• You cannot charge the USB mass storage class device while
connecting it to the USB MEMORY jack.
• While playing back a file in a USB mass storage class device, do not
disconnect the device. It may cause a malfunction of both the system
and the device.
• JVC bears no responsibility for any loss of data in the USB mass
storage class device while using this system.
• When connecting with a USB cable, use a cable less than 1 m in
length.
• This system is compatible with the USB 2.0 Full-Speed (not
compatible with the USB 1.1).
• You can play back the following types of files in a USB mass storage
class device (maximum data transfer rate: 2 Mbps):
– Music: MP3, WMA
– Picture: JPEG
– Movie: MPEG-4 (ASF), DivX (maximum frame rate of 30 fps for
progressive)
• You cannot play back a file larger than 2 GB.
• When playing a file which has a large transfer rate, frames or sounds
may be dropped during playback.
• This system cannot recognize a USB mass storage class device whose
rating exceeds 5 V/500 mA.
• This system may not recognize some USB mass storage class devices.
• This system may not play back some files even though their formats
are listed above.
.
Make sure that all other connections have been completed.
CAUTION
• Disconnect the power cord before cleaning or moving the system.
• Do not pull on the power cord to unplug the cord. When unplugging
the cord, always grasp and pull the plug so as not to damage the cord.
• If the AC outlets do not match the AC plugs, use the supplied AC plug
adapter
(except for the countries of the Middle East)
.
Connecting a USB mass storage
class device
Center unit (on the
front panel)
USB cable (not supplied)
Connecting the power cord
Center unit
Powered subwoofer
Power cord (supplied)
Power cord
Plug into AC outlet.
SP-PWC90
SP-PWC60/SP-PWC20
Plug into AC outlet.
Plug into AC outlet.
Power cord
Connections
Do not connect the power cord until all other connections have been made.
EN_TH-C906020[USUGUX].book Page 15 Thursday, June 29, 2006 5:30 PM