Juniper Networks IDP SERIES IDP250 - Manual (Page 65)

CHAPTER 9
Installing Field Replaceable Units
This chapter includes the following topics:
• Replacing a Power Supply on page 53
Replacing a Power Supply
The following procedure applies to models for which the power supply is a field
replaceable unit (FRU).
The appliance has two removable, hot-swappable power supplies. Units are shipped
with AC power supplies. You can order optional DC power supplies as FRUs.
Table 15 on
page 53 lists the part numbers for IDP Series power supply FRUs.
You can also order a replacement power cord. The part number for the power cord is
CBL-JX-PWR-Country (varies by country).
Table 15: Part Numbers for IDP Series Power Supply FRUs
Part Number Model
UNIV-PS-300W-AC IDP250
UNIV-PS-400W-AC
UNIV-PS-710W-DC
IDP800
UNIV-PS-700W-AC
UNIV-PS-710W-DC
IDP8200
To remove a power supply:
1. Go to the back of the device and locate the power supply you want to remove.
2. Locate the horizontal handle and the red lever in the upper left corner of the power
supply.
3. Lift the handle and push the lever to the right to unlatch the power supply.
4. With the lever pushed to the right, pull on the handle firmly to dislodge the power
supply from its seating.
53 Copyright © 2012, Juniper Networks, Inc.