Juniper Networks IDP SERIES IDP250 - Manual (Page 18)

Table 7: Management Port LEDs
Description State LED
Link is present. Glows green LINK
Activity. Blinks green
No link is present. Off
Connection is 1000 Mbps. Orange TX/RX
Connection is 100 Mbps. Green
If LINK indicates activity, TX/RX off indicates connection
is 10 Mbps.
If LINK indicates no activity, TX/RX off indicates no activity
as well.
Off
High Availability Interface Port
The high availability interface port is a 10/100/1000 Mbps Ethernet port. In the
configuration and logs, the port is
eth1 . The high availability interface is a dedicated
interface used to share state information among IDP appliances in a high availability
cluster.
NOTE: IDP OS 5.1 supports high availability. IDP OS 5.0 does not support
high availability.
Figure 3 on page 6 shows the management interface port LEDs.
Figure 3: High Availability Interface Port LEDs
Table 8 on page 7 describes the high availability interface port LED states.
Copyright © 2012, Juniper Networks, Inc. 6
IDP250 Installation Guide