Juniper Networks IDP SERIES IDP250 - Manual (Page 35)

CHAPTER 4
Installing the Appliance to Your
Equipment Rack and Connecting Power
This chapter includes the following topics:
• Rack Mounting Kits and Required Tools on page 23
• Mounting to Midmount Brackets on page 24
• Mounting to Rack Rails on page 25
• Connecting Power on page 25
Rack Mounting Kits and Required Tools
Table 12 on page 23 describes the rack mounting hardware included in a standard
shipment and required tools that are not included in a standard shipment.
Table 12: Rack Mounting Hardware and Required Tools
Description Hardware
The standard shipment for 1 RU models includes a single pair of mounting
brackets/ears. Use the brackets as follows:
• Position the brackets in the front position to front-mount.
• Position the brackets in the middle position to midmount.
If you require additional rack mounting hardware, such as rack rails, contact
your sales representative for details on rack mounting kits to suit your needs.
The part number for the standard rail kit is UNIV-MR1U-RAILKIT.
Rack mounting kit
The following tools are not included in the standard shipment and are required
to install the appliance into an equipment rack:
• Number 2 Phillips-head screwdriver
• Rack-compatible screws
Required tools
Related
Documentation
Mounting to Midmount Brackets on page 24 •
• Mounting to Rack Rails on page 25
23 Copyright © 2012, Juniper Networks, Inc.