Chapter 7: adding the idp appliance to nsm, Reviewing compatibility with nsm, Adding a reachable idp series device to nsm – Juniper Networks IDP SERIES IDP250 User Manual

Page 53: Chapter 7, Adding the idp appliance to nsm, 41 adding a reachable idp series device to nsm, Adding a

CHAPTER 7

Adding the IDP Appliance to NSM

This chapter includes the following topics:

•

Reviewing Compatibility with NSM on page 41

•

Adding a Reachable IDP Series Device to NSM on page 41

Reviewing Compatibility with NSM

Review the release notes for information regarding compatibility between your IDP Series
release and NSM release.

In some cases, you might be required to install a schema update on NSM to support the
IDP Series release. If so, follow the instructions in the release notes to install the schema
update.

NOTE:

The schema update is also known as the forward support update.

Documentation

Adding a Reachable IDP Device to NSM on page 41

•

Adding a Reachable IDP Series Device to NSM

This procedure assumes the IDP Series device is reachable. A reachable device is a device
you have installed and initialized, including configuring an IP address for the management
interface and connecting the management interface to the network. You complete the
reachable device workflow in cases where you set up the IDP Series appliance first and
add it to NSM second.

For information on a workflow where you add the device to NSM first and set up the IDP
Series appliance second, see the IDP Series Administration Guide.