JVC RM-SR774XU - Manual (Page 50)

47
English
Using the On-Screen Menus
You can use the Menus on the TV screen to control the receiver.
To use this function, you need to connect the TV to the MONITOR OUT jack on the rear panel (see page
15), and set the TV’s input mode to the proper position to which the receiver is connected.
Selecting the Source to Play (Also see page 20)
1. Press any button of ON SCREEN CONTROL % / fi / @ / # once.
The MAIN MENU appears on the TV.
2. Press ON SCREEN CONTROL
% / fi to move
to “SOURCE.”
3. Press ON SCREEN CONTROL @ / # to select the source.
4. When you finish, press EXIT.
The menu disappears from the TV.
Selecting the Different Sources for Picture and Sound
You can view the pictures played back on a video component while listening to any
source.
1. Press any button of ON SCREEN CONTROL % / fi / @ / # once.
The MAIN MENU appears on the TV.
2. Press ON SCREEN CONTROL
% / fi to move
to “VISUAL.”
3. Press ON SCREEN CONTROL @ / # to select a different video source.
• When you select “OSD,” see page 56.
4. When you finish, press EXIT.
The menu disappears from the TV.
Using the DSP Modes (Also see pages 34, 36, and 39)
1. Press any button of ON SCREEN CONTROL % / fi / @ / # once.
The MAIN MENU appears on the TV.
2. Press ON SCREEN CONTROL % / fi to move to “MODE.”
3. Press ON SCREEN CONTROL
@ / # to select the DSP mode you want to use.
4. When you finish, press EXIT.
The menu disappears from the TV.
MAIN MENU
Shows the buttons you can use on the current
menu.
In this case, use
% / fi to move up and
down, and @ / # to select, adjust or set the
item.
Notes:
• If your TV is not of the PAL
color system, the TV screen
will be distorted.
• The on-screen display will
disappear if no operation is
done for about 1 minute.
MAIN MENU
MAIN MENU
EN47_72.RX-774P[U]/1 98.3.10, 2:53 PM 47