JVC RM-SR774XU - Manual (Page 49)

46
English
IMPORTANT:
When using the Remote Control, check to see if its remote control
mode selector is set to the correct position:
To operate this receiver, set it to “AUDIO/TV/VCR (except when
selecting the DBS tuner as the source).”
From the remote control:
1. Press DVD MULTI so that “DVD MULTI” appears
on the display.
Each time you press the button, the source alternates
between “DVD” and “DVD MULTI.”
2. Select the analog discrete output mode on the DVD
player, and start playing a DVD.
• Refer to the manual supplied with the DVD player.
If you need to make any adjustment, go to the following steps.
3. Press SOUND CONTROL.
10 keys are activated for adjusting the sound.
4. Press CNTR +/– to adjust the center speaker output
level.
• Pressing CNTR – decreases the output level up to
–10 dB.
• Pressing CNTR + increases the output level up to
+10 dB.
5. Press REAR•(L) +/– to adjust the left rear speaker
output level.
• Pressing REAR•(L) – decreases the output level up to
–10 dB.
• Pressing REAR•(L) + increases the output level up to
+10 dB.
6. Press (REAR•R) +/– to adjust the right rear speaker
output level.
• Pressing (REAR•R) – decreases the output level up to
–10 dB.
• Pressing (REAR•R) + increases the output level up to
+10 dB.
7. Press CENTER TONE to select the center tone level.
Each time you press the button, the display changes to
show the following:
To make the dialogue clearer, select “SHARP1” (little) or “SHARP2” (much).
To make the dialogue softer, select “SOFT1” (little) or “SOFT2” (much).
When “FLAT” is selected, no adjustment is applied.
AUDIO/TV
/VCR
CATV
/DBS
DVD MULTI
SOUND
CONTROL
CNTR
2 3
MENU
Note:
You cannot adjust the center
speaker level when “CENTER
SPK” is set to “NONE” (see
page 24).
Note:
You cannot adjust the left rear
speaker level when “REAR SPK”
is set to “NO” (see page 25).
REAR (L)
5 6
ENTER
(REAR R)
8 9
Note:
You cannot adjust the right rear
speaker level when “REAR SPK”
is set to “NO” (see page 25).
Note:
The center tone cannot be
adjusted when “CENTER SPK”
is set to “NONE” (see page 24).
CNTR TONE
1
SHARP1 SHARP2 FLAT SOFT2 SOFT1
EN20_46.RX-774P[U]/1 98.3.10, 2:52 PM 46