JVC RM-SR774XU - Manual (Page 45)

42
English
4. Press BALANCE/SURROUND ADJUST repeatedly
until “CENTER TONE” appears on the display.
The display changes to show the current setting.
5. Turn MULTI JOG to select the center tone level you
want, while the indication of the previous step is still
on the display.
As you turn it, the display changes to show the
following:
If you have selected Theater Surround, go to the following steps.
6. Press BALANCE/SURROUND ADJUST repeatedly
until “DSP EFFECT” appears on the display.
The display changes to show the current setting.
7. Turn MULTI JOG to select the effect level, while the
indication of the previous step is still on the display.
As you turn it, the effect level changes as follows:
As the number increases, the surround effect becomes stronger.
MULTI JOG
BALANCE/ SURROUND
ADJUST
Note:
The center tone cannot be
adjusted when “CENTER SPK”
is set to “NONE” (see page 24).
SHARP1 SHARP2 FLAT SOFT2 SOFT1
DSP EFFECT 1 DSP EFFECT 2
DSP EFFECT 4
DSP EFFECT 3
DSP EFFECT 5
Note:
When you have selected Dolby
Pro Logic, you cannot select the
effect level.
MULTI JOG
BALANCE/ SURROUND
ADJUST
Note:
Once you have adjusted the
Surround modes, the
adjustment is memorized for
each Surround mode.
EN20_46.RX-774P[U]/1 98.3.10, 2:52 PM 42