JVC RM-SR774XU - Manual (Page 27)

24
English
Using the Sleep Timer
Using the Sleep Timer, you can fall asleep to music and know the receiver will turn off
by itself rather than play all night.
From the remote control only:
Press SLEEP repeatedly.
The shut-off time on the display changes as follows, and the
SLEEP indicator lights up on the display.
When the shut-off time comes
The receiver turns off automatically.
To check or change the time remaining until the shut-off time
Press SLEEP once.
The remaining time until the shut-off time appears in minutes.
•
To change the shut-off time, press SLEEP repeatedly.
To cancel the Sleep Timer
Press SLEEP repeatedly until “SLEEP 00min.” appears on the display. (The SLEEP
indicator goes off.)
Turning off the power also cancels the Sleep Timer.
Setting Center and Rear Speakers for DSP Modes
To obtain the best possible surround sound of the DSP modes, you have to register the
information about the speakers arrangement after all connections are completed.
Center Speaker Setting
Register the center speaker size.
On the front panel only:
1. Press SETTING repeatedly until “CENTER SPK”
(Center Speaker Size) appears on the display.
The display changes to show the current setting.
2. Turn MULTI JOG to select the appropriate item
about your center speaker, while the indication of the
previous step is still on the display.
As you turn it, the display changes to show the
following:
LARGE: Select this mode when the size of the center speaker is the same as
that of the front speakers.
SMALL: Select this mode when the size of the center speaker is smaller than
that of the front speakers.
NONE: Select this mode when you do not use a center speaker.
SLEEP
(Canceled)
SLEEP 20min. SLEEP 10min. SLEEP 30min.
SLEEP 40min.
SLEEP 90min.
SLEEP 00min.
SLEEP 50min.
SLEEP 80min. SLEEP 70min. SLEEP 60min.
SETTING
MULTI JOG
Note:
When you change your
speakers, you need to register
the information about the
speakers again.
LARGE SMALL NONE
EN20_46.RX-774P[U]/1 98.3.10, 2:50 PM 24