Juniper Networks EX2200 - Manual (Page 68)

CAUTION: The AC power cord for each switch is intended for use with that
switch only and not for any other use.
NOTE: In North America, AC power cords must not exceed 4.5 meters
(approximately 14.75 feet) in length, to comply with National Electrical Code
(NEC) Sections 400-8 (NFPA 75, 5-2.2) and 210-52 and Canadian Electrical
Code (CEC) Section 4-010(3). The cords supplied with the switch are in
compliance.
Table 21 on page 48 lists AC power cord specifications provided for each country or region.
Table 21: AC Power Cord Specifications
Plug Standards Electrical Specifications Country/Region
AS/NZ 3112 250 VAC, 10 A, 50 Hz Australia
GB2099 and GB1002 250 VAC, 10 A, 50 Hz China
CEE (7) VII 250 VAC, 10 A, 50 Hz Europe (except Italy, Switzerland, and
United Kingdom)
CEI 23-16 250 VAC, 10 A, 50 Hz Italy
JIS C8303 125 VAC, 12 A, 50 Hz or 60 Hz Japan
NEMA 5-15 125 VAC, 13 A, 60 Hz North America
SEV 1011 SEV 6534/2 250 VAC, 10 A, 50 Hz Switzerland
BS 1363/A 250 VAC, 10 A, 50 Hz United Kingdom
Figure 13 on page 48 illustrates the plug on the power cord for each country or region
listed in Table 21 on page 48.
Figure 13: AC Plug Types
Related
Documentation
• Power Supply in EX2200 Switches on page 14
• General Safety Guidelines and Warnings for EX Series Switches on page 113
• General Electrical Safety Guidelines and Warnings for EX Series Switches on page 141
• Prevention of Electrostatic Discharge Damage on EX Series Switches on page 142
Copyright © 2010, Juniper Networks, Inc. 48
Complete Hardware Guide for EX2200 Ethernet Switches