Jensen VM8012 User Manual

Page 8

VM8012

FRONT PANEL RELEASE

The front panel release button (4) releases the mechanism that holds the

front panel to the chassis.
Detaching the Front Panel
To detach the front panel, perform the following steps:
1. Press the power button (2) to turn the unit off.

2. Press the front panel release button to flip the panel down.

3. Grasp the right side to release the front panel and then pull it at an

angle to remove the right side from the chassis.

4. Store the front panel it in the supplied carrying case to protect it from dirt

and damage and take it with you to prevent theft.

Re-attaching the Front Panel
Before re-attaching the front panel, make sure the electrical terminals on

the back of the panel are free of dust and dirt, as debris could cause

intermittent operation or other malfunctions.
To re-attach the front panel:
1. With the panel laying flat (in the “open” position), insert the left side of

the panel in place until correctly engaged.

2. Gently press the right side of the panel until the mechanism locks it into

place.

3. Lift upward to close the panel.