Jensen VM8012 - Manual (Page 10)

VM8012
6
OPERATION
Power
Press the (power) button (2) to turn the unit on. Press and hold the power
button again to turn the unit off.
NOTE: LCD panels may take longer to respond when subjected to cold
temperatures for an extended period of time. In addition, the visibility
of the numbers on the LCD may decrease slightly. The LCD display
will return to normal when the temperature increases to a normal
range.
Source
Press the SRC button (6) to select a different mode of operation, as
indicated on the display panel. Available modes include tuner (FM1, FM2,
FM3, AM1, AM2), DVD, SD, USB, and auxiliary (AUX).
Audio Mute
Press the MUTE button (21) to silence the audio volume. “ ” appears on
the display. Press MUTE again to restore volume to the previous setting.
Volume Control
To increase the volume, turn the rotary encoder (5) clockwise. To decrease
the volume, turn the rotary encoder counter-clockwise. When volume is
adjusted, the volume level will be shown on the display panel as a number
ranging from “0” (lowest) to “63” (highest).
Audio Menu
Press the MENU button (5) to access the audio menu. Press the MENU
button repeatedly to move through the list of menu options.
• BASS: Turn the rotary encoder (5) to adjust the bass level from “+7” to
“-7”.
• TREBLE: Turn the rotary encoder to adjust the treble level from “+7” to
“-7”.
• BALANCE: Turn the rotary encoder to adjust the balance from “R7” (full
right) to “L7” (full left).
• FADER: Turn the rotary encoder to adjust the fader from “F7” (full front)
to “R7” (full rear).
The unit automatically exits the audio control menu after five seconds of
inactivity.
Menu Operation
Press and hold
the MENU button (5) for more than two seconds to access
the menu. Press the MENU button to move through the following menu
options: EQ MODE, BEEP, 12/24 MODE (clock), VOL MODE, A-VOL,
SUBWOOFER, SUB VOL. The following procedures assume you have
already accessed the menu.
Equalizer Selector (EQ MODE)
The equalizer function applies preset sound effects to the unit’s audio
output signal. Turn the rotary encoder to select from the following equalizer
options: “OFF”, “ROCK”, “POP”, “CLASSIC” and “FLAT”. With the equalizer
function activated, if bass or treble is adjusted, the EQ Mode will revert to
OFF.
When the equalizer function is activated, the most recently selected bass/
treble levels cannot be adjusted. When the equalizer function is not active,
the unit will return to the most recently selected bass and treble levels.
20 21
INT
RPT RPT
RDM
LOUD
ST/MO
LOC MUTE
AS BAND DISP SRC
1
2
3 6
5
4
/