beautypg.com

IBM AS/400 User Manual

Page 80

background image

AS/400 Prompt

AS/400 Parameter

4680 Link Parameter

Local location
address

LOCADR

4680 SESSION ADDRESS parameter must match the LOCADR
parameter specified on the AS/400 CRTDEVRTL command. Session
address 01 is reserved for host command processor sessions.

SSCP identifier

SSCPID

4680 SSCP ID parameter must match the SSCPID parameter specified on
the AS/400 CRTCTLRTL command.

Matching AS/400 parameters for 4684 retail controllers

You must coordinate parameter values with the AS/400 and the 4684 retail controller when running IBM
Retail Industry Programming Support Services (RIPSS). The following table lists those parameters.

AS/400 parameters are listed in alphabetical order; the commands on which the parameters are specified
are included in the rightmost column of the table.

For more information about configuring for RIPSS on the 4684, see the IBM Retail Industry Programming
Support Services: Planning and Installation Guide
, SC33-0650.

To configure the AS/400 to a 4684 controller:
v See “Examples: Connecting AS/400 to a 4690 retail controller” on page 75 for an example of an AS/400

connecting to a 4690 retail controller.

v Use the following table to connect to a 4690 retail controller.

AS/400 Prompt

AS/400

Parameter

RIPSS Configuration

Display

RIPSS Prompt

LAN remote
adapter address

ADPTADR

TRDLC Server Data

Local node (Hex)

For Token-Ring connections, the values specified
for the RIPSS configuration and for the AS/400
CRTCTLRTL command must match.

Local adapter
address

ADPTADR

TRDLC Server Data

Remote node (Hex)

For Token-Ring connections, the values specified
for the RIPSS configuration and for the AS/400
CRTLINTRN command must match.

Destination service
access point

DSAP

TRDLC Server Data

Local SAP (Hex)

For Token-Ring connections, the values specified
for the RIPSS configuration and for the AS/400
CRTCTLRTL command must match.

Duplex

DUPLEX

SDLC Server Data

4-wire constant RTS?

For SDLC connections, the values specified for
RIPSS and AS/400 configurations must match:
v If the RIPSS response is N, DUPLEX(*HALF)

must be specified for the CRTLINSDLC
command.

v If the RIPSS response is Y, DUPLEX(YES) must

be specified for the CRTLINSDLC command.

74

Version 5