IBM AS/400 - Manual (Page 66)

AS/400
Prompt
AS/400
Parameter
3174
Configuration
Questions Notes
Local network
address NETADR 423 Host DTE Address (HNAD)
For X.25 SVCs, the network address specified on the
CRTLINX25 command and in question 423 must match.
NRZI data
encoding NRZI 313 NRZ or NRZI Encoding
For SDLC lines only, the values specified on the
CRTLINSDLC command and in question 313 must match as
follows:
v If NRZI(*NO), 313 = 0
v If NRZI(*YES), 313 = 1
Source service
access point SSAP 940 Ring Address Assignment
The value specified for the SSAP parameter on the
CRTCTLRWS command must match the SAP@ associated
with the Ring@ (adapter address) of the AS/400 system on
the Ring Address Assignment display. Used for token-ring
only.
Short-hold
mode SHM 367 X.21 Switched Short-Hold Mode
Values specified on the CRTCTLRWS command and in
question 367 match as follows:
v If SHM(*NO), 367 = 0
v If SHM(*YES), 367 = 2
Station address STNADR 104 Control Unit Address
Value specified for question 104 must match the STNADR
specified on the CRTCTLRWS command.
Switched
connection SWITCHED 317 Telecommunication Facilities
Values specified on the CRTLINSDLC command and in
question 317 match as follows:
v If SWITCHED(*NO), 317 = 0
v If SWITCHED(*YES), 317 = 1
Note: If you are using a 3174 Model 1L Gateway to connect an AS/400 system to a host system on a Token-Ring,
the value specified for item 900 (Token-Ring Network Address of the Gateway) must match the value specified for
the ADPTADR parameter on the CRTCTLHOST command.
Matching AS/400 parameters for a 3274 controller
You match the AS/400 configuration parameters with the configuration questions and sequence numbers
to configure the 3274 controller. These parameters are described in the following table.
For more information about configuring the 3274 controller, see the 3274 Control Unit Planning, Setup, and
Customizing Guide.
To configure the AS/400 to a 3274 controller:
v See “Example: Connecting an AS/400 to a 3174 control unit” on page 61 for an example of connecting
an AS/400 to a 3174 retail controller.
v Use the following table to connect an AS/400 to a 3274 controller.
60 Version 5