IBM AS/400 - Manual (Page 54)

The following diagram shows the AS/400 parameters and 5494 parameters that need to match when you
use frame relay.
Matching AS/400 parameters for a 5494 connected by SDLC
You must coordinate communications configuration parameters between AS/400 and the 5494 controller
that is connected by SDLC. These parameters are described in the following table. Then the related fields
and subfields from the 5494 configuration display are listed next. These values are followed by the AS/400
configuration value and the matching 5494 value to be entered in the display subfield. You can coordinate
these values automatically or manually. Pick one of these ways:
v To automatically connect the AS/400 to a 5494 controller, you can use the automatic remote controller
(QAUTORMT) system value.
v To manually connect the AS/400 to a 5494 controller:
– See “Example: Connecting AS/400 to a 5494 controller connected by SDLC” on page 50 for an
example of connecting AS/400 to a 5494 controller by SDLC
– Use the following table to configure the AS/400 connected by SDLC.
48 Version 5