IBM 8260 - Manual (Page 9)

2.2 Step 2: Download Inband the 8260 A-CPSW
operational microcode
Upgrade the new active A-CPSW operational microcode as follows:
1 Configure the TFTP parameters by entering the following commands:
Ÿ SET TFTP SERVER_IP_ADDRESS
Ÿ SET TFTP FILE_TYPE OPERATIONAL
Ÿ
SET TFTP FILE_NAME
Ÿ
Type the full path name of the operational microcode file when prompted (its actual name is
indicated in the Readme file).
2 Make sure you can reach the TFTP server by entering:
PING
(Stop PING by entering: Ctrl+C)
3 Start the download inband procedure by entering:
DOWNLOAD INBAND
When prompted, type "Y" to confirm.
4 Wait for successful termination of the download operation. The message Download successful
is displayed.
This may also be checked by displaying the TFTP last transfer result through the command:
"SHOW TFTP".
The command "SHOW DEVICE" displays the downloaded operational code level as backup.
It should display : v. 3.1.9.
2.3 Step 3 : Download Inband the 8260 A-CPSW FPGA
picocode
This operation should be done only if your CPSW FPGA level is not uptodate, the latest
level is B52.
1 Configure the TFTP parameters by entering the following commands:
Ÿ SET TFTP SERVER_IP_ADDRESS
Ÿ
SET TFTP FILE_TYPE FPGA
Installation Instructions
Copyright IBM Corp. 1998
Page 9 June 17 1998 EC : F34705 PN : 26L0227