IBM 8260 - Manual (Page 12)

2 FPGA CODE (If necessary)
3 BOOT CODE
4 Activate the new version of A-CPSW FPGA. picocode by entering the command:
Ÿ SAVE ALL
Ÿ
SWAP FPGA_PICOCODE 9 (or 11).The telnet session, if any, is broken.
Ÿ Login as Administrator on the A-CPSW console.
5 Activate the new version of A-CPSW microcode by entering the command:
Ÿ
SWAP MICROCODE and confirm with Y. Your remote TELNET session is broken and you
have to connect locally an ASCII terminal to the A-CPSW console port to get the connectivity
again.
Ÿ
Login as Administrator on the A-CPSW ASCII console.
6 If you do not have redundant A-CPSW, go to step 7.
If you had already swapped new FPGA picocode and microcode on both A-CPSW
modules go to step 7. Check the new levels of codes .
The following table lists the microcode and FPGA versions that
must be displayed at completion of the upgrade. Use the following commands
Ÿ SHOW DEVICE
Ÿ
SHOW MODULE VERBOSE
v.3.1.9 v.3.1.9 B52 A-CPSW
Boot EEPROM
Version Flash EEPROM
version FPGA version Component
Now make this A-CPSW be secondary again as it was before the beginning of the
migration :
Ÿ
SET DEVICE ROLE SECONDARY
Ÿ
SAVE ALL
Ÿ RESET ATM_SUBSYSTEM
Ÿ The hub will reset and the backup A-CPSW will become active.
Ÿ
Perform the step 6 again on the other A-CPSW.
Installation Instructions
Copyright IBM Corp. 1998
Page 12 June 17 1998 EC : F34705 PN : 26L0227