beautypg.com

4 out of band download method – IBM 8260 User Manual

Page 7

background image

4. Check that you can PING the TFTP server from the 8260 LEC.

MM

Serial Line IP support (SLIP) mode.Make sure your workstation can act as a TFTP

server .

1. Set up a A-CPSW Configuration Console in SLIP Mode:

2. Then configuring the SLIP interface on the TFTP workstation will allow you to perform Inband

Download between your workstation and the A-CPSW.

3. The SLIP connection will be broken after a reset of the A-CPSW and connection will be

operational in normal mode.

1.4 Out of Band Download method

Ÿ

FPGA picocode cannot be downloaded using this method, only boot and operational.

Ÿ

Download can only be performed on active CPSW.

Once you have the code on your A-disk or hard disk, and you have connected your PC on the
RS232 port, using an RS232 emulated terminal, you have to type the following commands on
the command line:

MAINTAIN

DOWNLOAD OUT-OF-BAND BOOT (or OPERATIONAL)

You then have to choose the Xmodem protocol and select the path where your code is
located.

Note: This method is not recommended since it takes more time than the In-Band
method.

Installation Instructions



Copyright IBM Corp. 1998

Page 7

June 17 1998

EC : F34705

PN : 26L0227