IBM 8260 - Manual (Page 13)

2.7 Step 7: Check the new levels of codes :
1 Login as ADMINISTRATOR on the active A-CPSW console
2 The following table lists the microcode and FPGA versions that must be displayed at
completion of the upgrade. Use the following commands
Ÿ SHOW DEVICE
Ÿ SHOW MODULE n VERBOSE
v.3.1.9 v.3.1.9 B52 A-CPSW
Boot EEPROM
Version Flash EEPROM
version FPGA version Component
WARNING
Because of the major differences of operations between PNNI-1 and SSI, all your PVC
are cleared, all logical links and static routes will be deleted.
Before performing any swap, record your network parameters for LOGICAL LINK,
STATIC ROUTE, ATM ADDRESS and VPC (record those information on a sheet of
paper):
Example for CLUSTER 1:
1. HUBb>SHOW LOGICAL_LINK ALL will display
PORT VPI ACN SIDE MODE SIG TRAF BWITH STATUS INDEX
3.1 3 02 USER ENABLE 3.1 ANY 85000 UP 1
2. HUBb>SHOW STATIC ROUTE will display :
INDEX ACN STATIC ROUTE
1 02 39.99.99.99.99.99.99.00.00.88.88.03
3. HUBb>SHOW DEVICE will display :
ATM ADDRESS: 39.99.99.99.99.99.99.00.00.77.77.01.02.00.00.82.60.01.02.00
4. HUBb>SHOW PVC ALL will display :
port id type Vpi/Vci Port Vpi/Vci Hnb Party Role QOS Status
1.01 4 PTM-PVC 1/50 4.01 2/40 3 0 Primary BE
Active
Installation Instructions
Copyright IBM Corp. 1998
Page 13 June 17 1998 EC : F34705 PN : 26L0227