Impex PHE 2000 - Manual (Page 9)

STEP 3 (See Diagram 3)
A.) Attach the Upper Frame (#4) onto the two Guide Rods (#18). Secure each Guide Rod
to the Upper Frame with on M10 x 1” Allen Bolt (#75) and
∅
¾” Washer (#87). DO NOT
tighten the Nuts and Bolts yet.
B.) Place the Upper Frame (#4) onto the top of the Vertical Frame (#5). Secure it with one
5 ½” x 2” Bracket (#27), two M10 x 2 ¾” Carriage Bolts (#72), two
∅
¾” Washers (#87),
and two M10 Aircraft Nuts (#89).
C.) Securely tighten all Nuts and Bolts previously installed.
D.) Attach the Backrest Board (#22) to the Backrest Support Frame (#12). Secure it with
two M8 x 1 5/8” Allen Bolts (#82) and
∅
5/8” Washers (#86).
E.) Attach the Backrest Support Frame (#12) to the Vertical Frame (#5). Secure it with one
M10 x 3 ½” Allen Bolt (#73), two
∅
¾” Washers (#87), and one M10 Aircraft Nut (#89).
F.) Thread the Long T-shape Lock Pin (#43) into the hole on the Vertical Frame. Insert the
Pin into selected hole on the Backrest Support Frame to obtain the desired Backrest
position.
G.) Attach the Seat Support Frame (#6) to the Vertical Frame (#5). Secure it with one M10
x 2 ¾” Carriage Bolt (#72),
∅
¾” Washer (#87), and M10 Aircraft Nut (#89).
8