Impex PHE 2000 - Manual (Page 16)

STEP 8 (See Diagram 8 & Upper Cable Loop Diagram)
A.) Attach the 154” Upper Cable (#34) to the opening on the front Upper Frame (#4). Make
sure the ball stopper is underneath the Frame. Attach a Pulley (#45) to the Cable.
Secure the Pulley with one M10 x 2 ½” Allen Bolt (#78), two
∅
5/8” x 5/8” Pulley
Bushings (#60), and one M10 Aircraft Nut (#89).
B.) Draw the Cable over the Pulley along the Upper Frame towards the back of the
machine to the opening in the middle of Upper Frame. Repeat Procedure B above to
install a Pulley.
C.) Draw the Cable around the Pulley then back to the upper open bracket on the back of
Front Press Base (#10). Attach a Pulley to the bracket. Secure it with one M10 x 1 ¾”
Allen Bolt (#80), two
∅
¾” Washers (#87), and one M10 Aircraft Nut (#89).
D.) Draw the Cable around the Pulley then towards the upper opening on the Vertical
Frame (#5). Repeat Procedure B above to install a Pulley.
E.) Draw the Cable around the Pulley and back to the lower open bracket on the back of
Front Press Base (#10). Repeat Procedure C above to install a Pulley.
F.) Draw the Cable around the Pulley then to the lower opening on the Upper Frame.
Repeat Procedure B above to install a Pulley.
G.) Draw the Cable underneath the Pulley then pull upward to the open bracket underneath
the Upper Frame. Repeat Procedure C above to install a Pulley.
H.) Draw the Cable around the Pulley then downward. Attach a Pulley to the two Double
Floating Pulley Brackets (#24). Repeat Procedure C above to install a Pulley. Let the
Bracket hanging for now.
I.) Draw the Cable around the Pulley then upward to the opening on the back of Upper
Frame. Repeat the Procedure C above to install a Pulley.
J.) Draw the Cable around the Pulley then downward to the Selector Rod (#41). Thread
the Head Bolt at end of the Cable into the Selector Rod.
15