Diagram 2 – Impex PHE 2000 User Manual

Page 8

STEP 2 (See Diagram 2)
A.) Place two

∅

2 ½” Rubber Bumpers (#65) on the Rear Base Frame (#2). Align the holes

and insert Two Guide Rods (#18) through the holes into the Rear Base Frame. Secure
each Guide Rod with one M10 x 1” Allen Bolt (#75) and

∅

¾” Washer (#87) from the

bottom of Rear Base Frame.

B.) Slide 14 Weight Plates (#48) onto the Guide Rods. Make sure all Plates are facing the

same direction. Insert the Selector Rod (#41) through the center hole on the Weight
Plates. Slide the Weight Selector Stem (#47) onto the Guide Rods.

C.) Use the L-shape Pin (#40) to select desired number of Weight Plates to Exercise. NOTE:

Each Plate weights 10 lbs. Please refer to the Weight Resistance Chart on page 24.

DIAGRAM 2