Integra DTR-8.3 - Manual (Page 36)

36
2. Using the Tuning and buttons
on the front panel, tune into the
station you desire.
• The tuner frequency changes in 100-kHz (50-kHz)
increments for FM and 10-kHz (or 9-kHz) increments for
AM.
• You can press the Tuning or button continuously for
more than 0.5 seconds to scan for an FM station in the
direction of the button you pressed (FM auto tuning mode).
After you release the button and a station is received in stereo,
the scanning stops.
Listening to Radio Broadcasts
One of the features of the DTR-8.3 that is most frequently used is its
ability to play FM and AM broadcast radio stations. The DTR-8.3
provides a number of listening modes perfect for listening to the
radio and getting the most out of your audio system. Also, by
presetting radio stations that you listen to frequently, you can select
them easily by pressing the CH
button on the remote controller.
When using the remote controller, select AV Amp in the Home
menu to display the operation menu.
Tuning into a radio station
1. Press the Tuner input source button.
Each time you press the Tuner button, the input source changes
between AM and FM.
When using the remote controller, you can also use the FM or
AM button on 4/4 page of the AV Amp pages.
+
–
CH
VOL
MUTE
CONT
+
–
LIGHT
L
FM Mode Tuning
Tuner
/
Tuner
FM Mode
Tuner
Tuning
Tuned in stereo
Band Frequency
Auto mode
“FM STEREO”
(Lights red)
Listening to a stereo radio station (FM mode)
When you tune into a radio station, TUNED
indicator appears in the display. If you tune into
an FM station in stereo, then “FM STEREO”
appears. If the signal is weak, it may be
impossible to tune into the station in stereo. In
such a case, press the FM Mode button on the
front panel. The AUTO indication disappears
and the radio station is output in the monaural
mode. To return to stereo, press the FM Mode
button again. “AUTO” appears. Some inter-
station noise may be heard, but the sound will
not cut in and out as it would if stereo was
selected.
DTR-8.3 Remote controller