Figure 6-19, Figure 6-20 – Intel SGI Altix 450 User Manual
Page 155

Adding or Replacing PCI/PCI-X Cards
007-4857-002
133
6.
To install a half-height PCI card in a carrier, follow these steps:
a.
Remove the two screws from the carrier guide bar, as shown in Figure 6-19.
Note: Take care not to lose the threaded inserts in the carrier guide bar.
b.
Loosen the third screw of the carrier guide bar.
c.
Place the half-height PCI card in the carrier so that the connector edge of the card rests
against the lower guide tab of the carrier (see Figure 6-19).
Figure 6-19
Mounting Half-height PCI Card into Carrier
d.
Move the carrier guide bar (adjustment rail) so that it holds the card firmly in place (see
Figure 6-20).
Figure 6-20
Moving Carrier Guide Bar to Secure Half-height PCI Card
Guide tab
Connector edge of PCI card
Remove T8 Torx screws
Loosen T8 Torx screw
Adjustment rail