Replacing the recline mechanism guard – Invacare Deluxe Three-Position IH6065 series User Manual
Page 23
SECTION 5—MAINTENANCE
23
1. Recline the recliner to raise the footrest
assembly. Refer to Reclining the Chair
on page 15.
2. Remove the four hex screws that secure
the existing footrest cushion to the
recline mechanism.
3. Align the four mounting holes of the
recline mechanism with the four
mounting holes of the new footrest
cushion.
4. Using four hex screws, secure the
footrest cushion to the recline
mechanism.
FIGURE 5.3 Replacing the Footrest
Replacing the Recline Mechanism Guard
NOTE: For this procedure, refer to FIGURE 5.4 on page 24.
NOTE: Right and left sides are determined from the userʹs seated position.
1. Engage wheel locks.
2. Carefully tip recliner onto the right side. Be sure there are no obstructions on or
around the floor before doing this.
3. Remove the side panel. Refer to Removing/Installing the Side Panel on page 28.
4. Remove four existing bolts A, B, C, and D from side frame as shown in FIGURE 5.4 on
5. Remove existing recline mechanism guard.
6. Position new recline mechanism guard against the side frame with the folded edge
down.
7. Align holes of new recline mechanism guard with holes on side frame.
8. Secure new recline mechanism guard to side frame with bolts A, B, C, and D. Securely
tighten.
9. Install the side panel. Refer to Removing/Installing the Side Panel on page 28.
10. Place chair in the upright position.
NOTE: If binding or pinching of recline mechanism guard occurs, contact Invacare.
11. Carefully tip recliner onto the left side. Ensure there are no obstructions on or around
the floor before doing this.
12. Repeat STEPS 3‐10 to install remaining recline mechanism guard.
Hex Screws
Footrest Cushion
Footrest
Assembly
Recline
Mechanism