Assembling model ih6077a – Invacare Deluxe Three-Position IH6065 series User Manual
Page 13
SECTION 3—ASSEMBLY
13
FIGURE 3.1 Assembling the Recliner - Assembling Models IH6074A and IH6065 series
Assembling Model IH6077A
NOTE: For this procedure, refer to FIGURE 3.2 on page 14.
1. Remove back assembly from its carton.
NOTE: Ensure that footrest is in the closed position before installing back assembly.
2. Lock the rear wheels. Refer to Locking/Unlocking the Rear Wheels on page 18.
3. Remove the side panels. Refer to Removing/Installing the Side Panel on page 28.
4. Position the back assembly over the seat frame as shown in Detail ʺAʺ in FIGURE 3.2
5. Align the holes in the back assembly brackets with the holes in the seat frame as shown
in Detail ʺAʺ in FIGURE 3.2 on page 14.
6. Insert a clevis pin through back assembly bracket and seat frame and secure with a
retaining ring as shown in Detail ʺAʺ in FIGURE 3.2 on page 14. Repeat for opposite
side.
7. Align the gas spring bracket with the holes of the mounting bracket on the center of
the seat frame.
8. Insert a clevis pin through the gas spring bracket and through the mounting bracket
on the seat frame and secure with a retaining ring.
9. Lift the plastic skirt mounted on the bottom of the seat.
10. Align the holes in the skirt to the holes in the chair back by fastening the hardware.
11. Install the side panels. Refer to Removing/Installing the Side Panel on page 28.
Back Frame with
Back Cushion
Hex Screw
Mounting Hole
Guide Tube
Mounting
Hole
Seat Frame
Rear Seat Frame
Crossbrace
Hex
Head
Screws
Mounting
Hole
Guide
Tube
Mounting
Hole
Hex
Screw
Plastic Skirt
Hex Head Screws
Plastic
Skirt
Rear Seat
Frame
Crossbrace
DETAIL “A” - PLASTIC SKIRT