Invacare Deluxe Three-Position IH6065 series - Manual (Page 22)

SECTION 5—MAINTENANCE
Invacare Mobile Recliners 22 Part No. 1141494
Model IH6077A
NOTE: For this procedure, refer to FIGURE 5.2.
Removing
1. Remove the pan head mounting screw that secures the recline cable to the existing
back cushion.
2. Remove the four long hex head screws that secure the back cushion to the back frame.
3. Remove the four short hex head screws from each of the two headrest brackets.
NOTE: Reinstall the pan head mounting screw on the new back cushion assembly in
approximately the same location as on the old back assembly.
Installing
1. Align new back cushion with seat and frame.
2. Install four long hex screws to secure the back cushion to the back frame as shown in
FIGURE 2. Securely tighten.
3. Secure the headrest bracket to the back cushion with four short hex screws. Securely
tighten.
FIGURE 5.2 Replacing the Back Cushion - Model IH6077A
Replacing the Footrest Cushion
ƽ WARNING
DO NOT stand on the footrest or seat when entering or exiting the recliner. The
recliner will tip and bodily injury may occur.
NOTE: For this procedure, refer to FIGURE 5.3 on page 23.
Headrest
Bracket
Push
Handle
Back
Frame
Long Hex
Screws
Pan Head
Mounting Screw
Long Hex
Screws
Short Hex
Screws
Back
Cushion