Intel ISP1100 - Manual (Page 47)

Removing/Installing Server Components 47
Removing the Rear I / O Filler Panel(s)
NOTE
Perform this procedure only if you are installing PCI add-in card(s) in unused
expansion slots that still have an I/O filler panel installed.
Perform this procedure to remove the rear I/O filler panel(s). Refer to Figure 26 while performing
this procedure.
1. Use a Phillips screwdriver and remove the two screws (A) securing the filler panel retention
bracket (B) to the top edge of the server back panel.
2. Remove the retention bracket.
3. Remove the filler panel (C) from the expansion slot for the add-in card(s) you are installing.
A
B
C
OMO9439
Figure 26. Removing the Rear I / O Filler Panel(s)